# Normal Distribution Probability Plotting Example

### From ReliaWiki

*This example appears in the Life Data Analysis Reference book*.

7 units are put on a life test and run until failure. The failure times are 85, 90, 95, 100, 105, 110, and 115 hours. Assuming a normal distribution, estimate the parameters using probability plotting.

In order to plot the points for the probability plot, the appropriate estimates for the unreliability values must be obtained. These values will be estimated through the use of median ranks, which can be obtained from statistical tables or from the Quick Statistical Reference (QSR) tool in Weibull++. The following table shows the times-to-failure and the appropriate median rank values for this example:

These points can now be plotted on a normal probability plotting paper as shown in the next figure.

Draw the best possible line through the plot points. The time values where the line intersects the 15.85%, 50%, and 84.15% unreliability values should be projected down to the abscissa, as shown in the following plot.

The estimate of is determined from the time value at the 50% unreliability level, which in this case is 100 hours. The value of the estimator of is determined as follows:

Alternately, could be determined by measuring the distance from to , or to , as either of these two distances is equal to the value of one standard deviation.