BlockSim Examples: Difference between revisions
Jump to navigation
Jump to search
Kate Racaza (talk | contribs) |
Kate Racaza (talk | contribs) |
||
| Line 46: | Line 46: | ||
*[[Example Using Subdiagram Phase Blocks|Using Subdiagram Phase Blocks]] | *[[Example Using Subdiagram Phase Blocks|Using Subdiagram Phase Blocks]] | ||
*[[Interval Maintenance Threshold Example|Using an Interval Maintenance Threshold in a Maintenance Phase]] | *[[Interval Maintenance Threshold Example|Using an Interval Maintenance Threshold in a Maintenance Phase]] | ||
*[[Phase Throughput Examples]] | |||
==State Change Triggers (SCTs)== | ==State Change Triggers (SCTs)== | ||
Revision as of 03:46, 22 August 2012
 |
Analytical Diagrams and Optimization
- Reliability Analysis of a Storage Cluster System - View it in HTML or Video
- Optimized Reliability Allocation - View it in HTML or Video
- Using RBDs for Modeling Failure Modes
- Analytical Diagram Plots
- Allocation Analysis
- Time-Dependent System Reliability for Components in Series
- Time-Dependent System Reliability for Components in Parallel
- Using a Distribution to Approximate the System cdf
- Calculating System Reliability with Duty Cycles
- Load Sharing Configuration Example - Failure Modes Analysis
- Standby Configuration Example - Car Tires
- Reliability Importance Plot Example
- Optimum Replacement Time Example
Fault Tree Diagrams
- Simple Examples for Fault Tree Gates
- Same Example Modeled with RBDs or Fault Trees (Modeling Failure Modes)
Simulation Diagrams
- RAM Analysis for Remote Telecommunications System
- Effect of Inspection Intervals
- Corrective Maintenance Triggered by Failure of a Subsystem
- Life Cycle Cost Analysis Example
Phase Diagrams
- Aircraft Phases with Forced Landing
- Oil Refinery Phase Diagram Simulation
- Using Success/Failure Paths in Phase Diagrams
- Using Subdiagram Phase Blocks
- Using an Interval Maintenance Threshold in a Maintenance Phase
- Phase Throughput Examples
State Change Triggers (SCTs)
- Using State Change Triggers for Standby Rotation
- Using State Change Triggers to Analyze Tire Maintenance
- Using State Change Triggers to Model Standby with Delay
- Using State Change Triggers to Model Two Standby Devices
- SCT: The State Upon Repair Option
- Demonstrating the "Default OFF unless SCT overridden" option
- Demonstrating the "Default ON unless SCT overridden" option
Throughput Analysis
Utilities
Due to continuous improvement in ReliaSoft software, the product images and step-by-step instructions featured in these resources may not always show the latest software version. Please visit www.hbkworld.com for the latest product info.