BlockSim Examples: Difference between revisions
Jump to navigation
Jump to search
Kate Racaza (talk | contribs) No edit summary |
Kate Racaza (talk | contribs) |
||
| Line 38: | Line 38: | ||
*[http://www.reliasoft.com/BlockSim/examples/rc3/index.htm Effect of Inspection Intervals] | *[http://www.reliasoft.com/BlockSim/examples/rc3/index.htm Effect of Inspection Intervals] | ||
*[[BlockSim_Example:_CM_Triggered_by_Subsystem_Down|Corrective Maintenance Triggered by Failure of a Subsystem]] | *[[BlockSim_Example:_CM_Triggered_by_Subsystem_Down|Corrective Maintenance Triggered by Failure of a Subsystem]] | ||
*[[Life Cycle Cost Analysis Example]] | |||
==Phase Diagrams== | ==Phase Diagrams== | ||
Revision as of 22:45, 21 August 2012
 |
Analytical Diagrams and Optimization
- Reliability Analysis of a Storage Cluster System - View it in HTML or Video
- Optimized Reliability Allocation - View it in HTML or Video
- Using RBDs for Modeling Failure Modes
- Analytical Diagram Plots
- Allocation Analysis
- Time-Dependent System Reliability for Components in Series
- Time-Dependent System Reliability for Components in Parallel
- Using a Distribution to Approximate the System cdf
- Calculating System Reliability with Duty Cycles
- Load Sharing Configuration Example - Failure Modes Analysis
- Standby Configuration Example - Car Tires
- Reliability Importance Plot Example
- Optimum Replacement Time Example
Fault Tree Diagrams
- Simple Examples for Fault Tree Gates
- Same Example Modeled with RBDs or Fault Trees (Modeling Failure Modes)
Simulation Diagrams
- RAM Analysis for Remote Telecommunications System
- Effect of Inspection Intervals
- Corrective Maintenance Triggered by Failure of a Subsystem
- Life Cycle Cost Analysis Example
Phase Diagrams
- Aircraft Phases with Forced Landing
- Oil Refinery Phase Diagram Simulation
- Using Success/Failure Paths in Phase Diagrams
- Using Subdiagram Phase Blocks
State Change Triggers (SCTs)
- Using State Change Triggers for Standby Rotation
- Using State Change Triggers to Analyze Tire Maintenance
- Using State Change Triggers to Model Standby with Delay
- Using State Change Triggers to Model Two Standby Devices
- SCT: The State Upon Repair Option
- Demonstrating the "Default OFF unless SCT overridden" option
- Demonstrating the "Default ON unless SCT overridden" option
Throughput Analysis
Utilities
Due to continuous improvement in ReliaSoft software, the product images and step-by-step instructions featured in these resources may not always show the latest software version. Please visit www.hbkworld.com for the latest product info.