BlockSim Example: CM Triggered by Subsystem Down

From ReliaWiki
Jump to navigation Jump to search

CM Triggered by Subsystem Down

Purposes

The purpose of this example is to illustrate how to model the case when CM is triggered by failure of subsystem. We present two kinds of methods: method without subdiagram and method with subdiagram. The limitation of the method without subdaigram is that, it cannot model subsystem with more than two devices in parallel or more complex structure. The method with subdiagram can break this limitation.

Method 1: Without subdiagram

Let’s consider a system with three devices A, B and C are in parallel. A and B form a subsystem AB. Only both A and B fail (subsystem AB fails), then start to repair A and B. Device C is parallel with subsystem AB. The repair of C depends on its failure. When C fails, then start to repair C.

BlockSim Solution

The BlockSim modeling of this system is shown in Figure below.

System CM triggered by subsystem down.png

Reliability of all blocks follow Weibull distribution with Beta =1.5 and Eta=500 hours.

Block A and Block B are belonging to maintenance group MG_AB.

CM of Block A and B are set to "When found failed during an inspection". The CM duration is 120 hour. Upon repair, they are as good as new.

There is an inspection for both block A and B. The inspection is performed based on events in maintenance group MG_AB. If "Block fails" or "Start of corrective maintenance" event occurs for any of the blocks in the maintenance group MG_AB, then the inspection is performed. The inspection duration is set to "Immediate Repair" and upon inspection; the device is restored to same as it was when it failed (as bad as old).

CM of Block C is performed upon failure of Block C and the duration is 20 hours. It is as good as new upon repair.

 Block Up/Down plot

The system event log is shown in Figure belwo and is as follows:

  1. At 271, Block C fails and get repair at 291.
  2. At 331, Block B fails. Since the subsystem AB is not down (Both A and B fails, then subsystem AB fails), Block B is waiting for repair opportunity after its failure. (Failure of Block B cannot trigger inspection of Block B, but this failure would trigger the inspection of Block A. However, Block A doesn't have failure at this time, thus nothing happens).
  3. At 381, Block A fails and subsystem AB fails. Subsystem fails trigger the inspection and then inspection triggers CM. (failure of Block A triggers an inspection on Block B, and Block B has failure at this point. Thus CM of Block B is performed. Performing CM on Block B triggers the inspection of Block A and Block A also has failure at this time, thus CM of Block A is performed too.)
  4. At 501, both Block A and B are restored.
  5. At 791, Block B fails and is waiting for repair opportunity.
  6. At 943, Block C fails and get restored at 963.
  7. At 1358, Block A fails and subsystem AB fails, triggering CM for Block A and B.
  8. At 1478, both Block A and B are restored.
  9. ...


CM triggered by susbystem failure Up Down plot.png